Feed Throughs & Battery Posts
Pass heavy DC battery cable through panels, bulkheads and battery boxes without chafing.
Feed Through Connectors and Bulkhead Battery Posts
A heavy battery or inverter cable run straight through a hole in a panel, deck or battery box rubs on the edge every time the vehicle or boat moves. Over time the insulation can wear through and short the cable to the panel. A feed through connector or bulkhead battery post fixes a stud through the panel instead. You terminate a cable on each side with a lug, so no cable passes through the hole and both runs are held firmly in place.
What's in This Range
- Blue Sea 250A terminal feed through connectors: a 5/16"-18 tin-plated copper alloy stud on a reinforced thermoplastic base, rated 250A continuous on systems up to 48V DC. Red and black.
- Enerdrive terminal feed through connectors: a 3/8"-16 stud (about M10) on an IP66-rated body. Red and black.
- Exotronic 250A bulkhead battery posts: brass M10 posts for panels up to 10mm thick, each with an insulated boot. Red and black.
Choosing and Installing
- Match the stud to your cable lugs: 5/16" (close to M8), or 3/8" and M10.
- Check the current rating against the cable and the fuse protecting it.
- Use red for positive and black for negative so polarity is clear on both sides of the panel.
- Where the panel separates a wet area from a dry one, gasket the mounting face or bed it in sealant.
Terminate cables with correctly sized crimp cable lugs. To split one feed into several circuits, use bus bars and studs. For quick-disconnect DC connections, see Anderson plugs.







Pre-Wired Boards
4x4/Canopy Power Systems
Solar Kits
Inverter Kits
Charger Kits
Battery Kits
Monitoring Kits







































